Email me when a new MSHA incident is filed at Camp Branch Mine.
| Quarter | Hours worked | Citations | S&S | Per 1M hrs |
|---|---|---|---|---|
| 2018 Q2 | 0 | 0 | 0 | |
| 2018 Q1 | 0 | 0 | 0 | |
| 2017 Q4 | 0 | 0 | 0 | |
| 2017 Q3 | 0 | 0 | 0 | |
| 2017 Q2 | 0 | 0 | 0 | |
| 2017 Q1 | 1,197 | 0 | 0 | 0.0 |
| 2016 Q4 | 2,440 | 0 | 0 | 0.0 |
| 2016 Q3 | 0 | 0 | 0 |
Employee was operating 777 Truck when EE slowed down and truck down shifted straining EE's back.
Member was taking the hook off the cable of an IMT Boom to put inside the cab on a Mack fuel truck to set a new transmission in place. When he pulled the pin out of the hook it fell, hitting his left little finger.
Member had finished fueling a 773 CAT truck and was getting back into his fuel truck. He slipped, causing him to strike his right knee on the step. He continued to work and then went to the emergency room. X-Rays were conducted and he was released back to work. Due to increased pain and swelling he was removed from work by the doctor on 9/2/2010.
Member was climbing a step ladder to gain access to the tilt cylinder jack when he lost his footing and fell landing on his right arm, fracturing his wrist.
Employee was attempting to mount an Ingersol DML drill by using the cab-side steps. While climbing the steps, his foot slipped causing him to fall to the ground landing on his feet. The impact caused pain in his lower back.
EE was walking down stairs to give his preshift to someone. His foot slipped and caught himself with his right hand on the step behind him, causing him to inujure his wrist.
Member was using a hammer and bolt to remove a pin from the roller frame of a D10R dozer. When the pin came out the roller frame dropped and pinched his left index finger between the roller frame and bolt.
Member was cutting a zip tie with a pocket knife and stabbed himself in the right leg above knee.
Member was coming down ladder from ECM level to pad level when he lost grip and fell to the ground.
Member was using pocket knife to cut wire tie when blade broke cutting members right hand.
Member was lifting an engine compartment door on a cat 992G loader.
Member was using a slate bar to pry the teay up on a hwm beam. the slate bar slipped and struck him on the right eye lid.