Email me when a new MSHA incident is filed at TROUP PLANT.
| Quarter | Hours worked | Citations | S&S | Per 1M hrs |
|---|---|---|---|---|
| 2025 Q4 | 9,349 | 1 | 0 | 107.0 |
| 2025 Q3 | 4,247 | 0 | 0 | 0.0 |
| 2025 Q2 | 3,911 | 5 | 1 | 1278.4 |
| 2025 Q1 | 3,120 | 3 | 1 | 961.5 |
| 2024 Q4 | 6,391 | 0 | 0 | 0.0 |
| 2024 Q3 | 3,919 | 14 | 1 | 3572.3 |
| 2024 Q2 | 4,085 | 0 | 0 | 0.0 |
| 2024 Q1 | 6,373 | 1 | 0 | 156.9 |
While repairing a damaged trunion tire, the employee needed to trim a piece of rubber in order to get the puller installed. The box knife being used slipped lacerating the employee's left ring finger.
Employee was attaching a trailer mounted pump to a track hoe bucket in order to move the pump into position. The track hoe bucket unexpectantly lowered, catching the employee's hand between the bucket and pump frame.
While treating mine water at Outfall 2, hydrated lime in the hopper escaped through a gap at the flow adjustment plate and hit the employee in the eyes. Employee immediately began flushing eyes with bottled water. Due to severe irritation, the employee was taken in for medical evaluation.
Wet Slick clay on boot when contacting the step, slipped, and hit shin on step.
Employee walking across parking lot and tripped straining ligament in left calf.
While repairing shredder tire, a sliver of metal stabbed employee in the left thumb. Employee removed the metal but a small piece remained embedded in the thumb causing infection and swelling.
While attempting to remove a machine guard to tighten drive belts employee experienced "pop" and tingling sensation in left shoulder.
While removing a damaged bearing with a shop hammer, a fragment of the housing struck the employee in the right forearm, causing a laceration.
Employee strained lower back while attempting to lift a four-inch rubber discharge hose that was partially filled with water.
EE was traveling from the shredded clay storage shed to the BC control room along a travel and fell onto concrete floor. Fall caused a laceration to EE right eyebrow, fracture of his cheek bone, and a contusion to his right shoulder. He also scratched his right hand while attempting to arrest the fall. After Med evaluation 11/15/13 EE needs surgery
The employee was adjusting the ball clay rail spur switch when his finger was pinched between two pieces of metal causing a laceration.
EE was attempting to reinstall a bucket tooth pin on an excavator. He was using a shop hammer to reinstall the pin and inadvertantly struck the tip of his left index finger, causing crushing injuries to the finger tip.
While using a sledge hammer to dislodge material during railcar unloading, the employee felt a pain in his lower abdomen/groin. Employee reported the injury on 10/14/08 at approximately 7:00am. The employee was taken to the doctor & was diagnosed with a hernia.
Employee was replacing the bolts on the cutting edge of the dozer blade. The round, flush mount bolt rotated as it was engaged by the pneumatic impact wrench causing a laceration to the employees left index finger.
EE WAS ABOUT TO SCRAPE AN OLD REGISTRATION STICKER OFF THE WINDSHIELD OF THE WATER TRUCK WHEN HE DROPPED THE RAZOR-TIPPED SCRAPER WHICH CUT HIS WRIST.
A HOME-MADE HOSE REEL THAT HAS BEEN USED FIFTEEN YEARS WITHOUT INCIDENT SHIFTED WHILE IN USE.
A 35" X 35" X 56" SUPERSACK FILLED WITH 1 TON OF POWDERED CLAY BEGAN TO FALL OVER. EE ATTEMPTED TO CATCH IT AND WAS PUSHED AND TRIPPED, FELL, AND SHATTERED HIS RIGHT ELBOW WHEN HE STRUCK THE C ONCRETE FLOOR.
EE WAS DRAGGING HOSE. FELT PAIN IN RIGHT SHOULDER.
EE WAS LIFTING FIBER BARREL OF SAMPLES & PLACING IT ON A PALLET UNDER STORAGE TRAILER.
EE ATTEMPTED TO LIFT CORE BARREL WITH BACK INSTEAD OF LEGS.