Email me when a new MSHA incident is filed at CCU Sexton Strip.
| Quarter | Hours worked | Citations | S&S | Per 1M hrs |
|---|---|---|---|---|
| 2025 Q4 | 6,833 | 0 | 0 | 0.0 |
| 2025 Q2 | 7,763 | 2 | 1 | 257.6 |
| 2024 Q4 | 9,200 | 0 | 0 | 0.0 |
| 2024 Q2 | 10,779 | 0 | 0 | 0.0 |
| 2024 Q1 | 12,335 | 0 | 0 | 0.0 |
| 2023 Q4 | 11,535 | 0 | 0 | 0.0 |
| 2023 Q3 | 13,730 | 0 | 0 | 0.0 |
| 2021 Q1 | 11,455 | 0 | 0 | 0.0 |
Employee was operating a DM45 Highwall Drill on a drill bench. Employee was traveling parallel to the edge and the outside edge gave way. The drill slid off the bench and landed 25 feet below.
Employee was climbing down step ladder and slipped off second step causing EE to loose EE's balance, fell stumbled backwards and hit EE's head on the bumper of EE's truck causing a cut that required stitches.
Employee was walking across parking lot and slipped on the ice landing on their shoulder. Continued to work until 2/24/22 when EE informed me of the accident and that it was not getting any better. I instructed EE to go to hospital and they found that EE had a cracked shoulder bone.
Employee was walking in parking lot and slipped on the ice. Employee fell on arm, continued to work until 3/16, elbow was not healing so they put employee on Restrictive duty.
EE was climbing down a step ladder and turned to put EE's foot on ground and felt EE's knee pop.
Employee was hooking up a suction hose to water pump and slipped in the mud causing employee to twist knee.
Employee was using a cutting torch in tight quarters and a spark caught his pants on fire, caused a small burn on leg.
Employee was stepping down off a tractor and missed the step causing him to slip and twist his ankle.
Employee was trying to remove a brass bushing from a shaft and when the first half came out the second half spun down around and caught his finger. Had 4 stitches
EE was checking the resistance of a rotor of a drive motor and pinched his fingers between the rotor and Brake caliper fracturing the tips of 2 fingers.
EE was working on a brake caliper that was locked in his vice and it slipped out and hit his hand. Had 3 stitches put in hand.
EE was running a 992 Cat front-end loader and was loading rock trucks. He was backing away from a truck with his boom in the air, he had not noticed that the keeper had come out of pin housing, which let the boom pin come out. The boom dropped and it shook the operator. Took two days off for soreness.
EE was operating a Blast Hole Drill when a drill steel came lose from the carrousel at the top of drill mast. He and the Mechanic was trying to set it back into the rack when the steel shifted and pinched his wrist between two drill steels. Took him to Hospital where they took xrays and found he had a hairline crack in his wrist.