Clayton Aggregates Metal/Non-Metal

EE was removing nuts from the secondary crusher frame with a 1" pneumatic impact wrench. When the nut broke free the rotational force of the pneumatic wrench spun the nut up the threads pinning EE's right index finger between the handle on the impact wrench and the overhang of the crusher frame. EE received 7 sutures to the outside of the right index finger.

Temporary scaffolding staircase was removed. Area was not safely cordoned off correctly. Employee fell from 7' elevated height at doorway with no stairs. Employee suffered bruising and laceration.

Injured employee examined what needed to be cleaned on the transfer screen to move the gates. EE was in a squatting position and barred the material that was stopping the gates from moving. In the squatting position EE grabbed the chute opening with hands out and when EE pulled self up EE felt a sharp pain in back and a popping sound.

An employee was hauling material to the dump grizzly, when they felt a pain in the lower back. The initial diagnosis was a strain to the lower back and they were returned to regular duties on 8/16/2014. No medical treatment was given at this time. The employee was further diagnosed and was removed from the duties on 6/9/2015.

From a previous injury that was being treated by the insurance carrier, the employee stated both knees and the back was getting sore again over the past few days. The employee was conducting their regular job operating the Pit Loader and Dozer periodically in the pit area.

Walking on an uneven surface while performing a pre-task inspection, left knee hyper-extended as he strode and hit a depression.

The employee was pumping a manual grease gun when he felt some pain in the right elbow. The employee was sent to the clinic and was diagnosed with a minor strain to the elbow. The employee was sent back to regular duty with no retractions. The modifications were given based on the California Workers Comp. criteria only.

Employee was climbing down into the feeder that was being installed into #2 conveyor tunnel. The 4' "A" frame ladder slipped from under him and he hit his right elbow and right shoulder. His left knee was reported as sore due to walking on even surfaces during this project.

EE was lifting two tools out of a crate and while doing so felt pain in his abdomen. A bump developed and was diagnosed as an umbilical hernia.

Employees welding lagging onto a tail pulley, injured employee said he caught a couple of flashes during the 11 hour shift. At the end of the shift he realized that he had received a flash burn in both eyes.

Slipped as he stepped off a ladder, twisting his left knee.

Two employees were replacing a bearing on the ecentric shaft of the Noble feeder in #2 conveyor tunnel. The shaft and bearings were supported by a chain and a chain hoist. One of the chains slipped allowing the bearing to twist and drop two inches, hitting employees left thumb and breaking it.

While operating an electrical hoist he caught his hand on the cable. His left ring finger became caught in the block.

Employee is claiming a cummulative trauma to left shoulder, specifically left shoulder rotator cuff tendonitis.

Employee was lifting a screen or gate when he felt pain in his low back.

Employee felt pain in his lower back when he bent over to connect cables from charger to welder battery.

EE WAS SHOVELING MATERIAL NEAR ONE OF THE CRUCHERS WHEN THE WIND BLEW DUST INTO HIS EYE.

EE WAS LIFTING SCREEN AND PLACING THEM IN A RACK; HE EXPERIENCED PAIN IN HIS SHOULDER AND NECK.

EE WAS PULLING ON GREASE LINE FROM SERVICE TRUCKWALKING BACKWARDS AT THE TIME & SLIPPED & FELL ON LOOSE GRAVEL IN AREA-FALLING BACKWARDS ONTO HIS BUTTOCKS. THERE WAS NO DIAGNOSIS UNTIL 4/19/00 FROM DRS.